EcoLeak ECO-SC-3 alarm panel with relay + 3 m linear flood sensor
- Domyślny opis krótki
The EcoLeak Eco-1 zone leak detection alarm panel for water leak detection comes complete with connection cable and in-line sensor.
The Eco-1 single-zone alarm panel includes damage / line break monitoring for added protection and peace of mind.
LEDs on the front panel indicate power, leakage alarm and wire break. In the event of a leak or fault, the alarm sounds and the corresponding LED lights up. The operator silences the audible alarm by pressing the MUTE button. After silencing the alarm, the "Leak" or "Cable break" LED will continue to light. Once the cause of the alarm has been located and corrected, the panel can be reset and the corresponding LED will turn off. Resetting the panel also resets the voltage-free contacts of the alarm relay. Eco-1 also has an "automatic reset" function. If enabled, it will allow the panel to reset itself after a leak or fault has been corrected. Any loss of system integrity, caused by a power interruption or a break in a sensor circuit, will trigger the "Break / Fault" relay.
The Eco-1's compact housing can be easily mounted on the wall. It provides visual and audible indications for small applications. External device connectivity is provided by two potential-free "Leak" and "Common" relays. These can be used to connect to local solenoid valves, BMS or other remote monitoring systems. A remote alarm panel (AT-RAP) can be added to the system for alarm signaling in separate locations such as reception and security rooms.
Eco-1 is ideal for projects where cost-effective leak detection and signaling solutions are required, such as smaller commercial areas or individual residential properties. Suitable areas include: elevator shafts, basements, storage technical rooms, tanks and pumping stations, kitchens, bathrooms, toilets, utility rooms and risers.
- Connection of a linear water detection sensor
- Voltage-free relay - leakage
- Voltage free relay - fault
- Power supply 230 V AC
- T500mA 250 V fuse
- Relay function selection
- Auto reset jumper
Line sensor - wire sensor detects water along its entire length
Linear sensor / wired sensor / sensor detects water anywhere along its length. In combination with the control panel for Eco-1 zones, the wire detects water leakage, triggers an alarm and indicates the leakage zone. The cable is available as a kit in lengths from 1 to 30 meters.
Conductive polymer technology and fluoropolymer construction make the EcoLeak sensor cable mechanically robust and resistant to corrosion and abrasion. The cable is constructed with two sensor wires embedded in a fluoropolymer support rod. The alarm module continuously monitors the continuity of the sensor wire. The wire's design allows it to be dried within seconds after water is removed and reused.
Pre-installed plastic male connector on one side, factory terminated on the other.
Connection cable with a length of 20 meters
Each kit includes a 20-meter connection cable (gray) on one side terminated with a connector to connect the sensor cable.
The water detection kit includes
- EcoLeak Eco-1 alarm panel
- Modular sensor cable that detects water anywhere along its length. Pre-installed plastic male connector on one side, factory terminated on the other side.
- Modular connection cable for connecting the sensor cable to the alarm module. Factory-installed plastic female connector on one side, factory-terminated on the other side, ready to be plugged into the terminal connectors of the alarm module.
- Adhesive clips for attaching the sensor cable to the ground.