EcoLeak ECO-10-1 set: linear flood sensor | 2 relays | 1 m sensor cable
EcoLeak Eco-1 zone water leak detection alarm panel under which a water detection sensor cable with a maximum length of 30 meters can be connected. This is a simple yet professional Eco-1 single-zone alarm panel that contains two relays. One responds to "Leak" and can be connected to a solenoid valve, pump or siren, the other activates in the event of a fault / break in the circuit which provides additional protection and peace of mind.
SIMPLE OPERATION
LEDs on the front panel indicate power, leakage alarm and wire break. In the event of a leak or fault, the alarm sounds and the corresponding LED lights up. The operator silences the audible alarm by pressing the MUTE button. After silencing the alarm, the "Leak" or "Cable break" LED will continue to light. Once the cause of the alarm has been located and corrected, the panel can be reset and the corresponding LED will turn off. Resetting the panel also resets the voltage-free contacts of the alarm relay. Eco-1 also has an "automatic reset" function. If enabled, it will allow the panel to reset itself after a leak or fault has been corrected. Any loss of system integrity, due to a power or sensor circuit break, will trigger the "Break / Fault" relay.
CONSTRUCTION
The Eco-1's compact housing can be easily mounted on the wall. It provides visual and audible indications for small applications. External device connectivity is provided by two potential-free "Leak" and "Break / Fault" relays. These can be used to connect to local solenoid valves, BMS or other remote monitoring systems. A remote alarm panel (AT-RAP) can be added to the system to signal alarms in separate locations such as reception areas and security rooms.
APPLICATIONS
Eco-1 is ideal for projects where cost-effective leak detection and signaling solutions are required, such as smaller commercial areas or individual residential properties. Suitable areas include: elevator shafts, basements, storage technical rooms, tanks and pumping stations, kitchens, bathrooms, toilets, utility rooms and risers.
EXAMPLE DIAGRAM
CONSTRUCTION
- Connection of sensor cable detecting water
- Voltage-free relay - leakage
- Voltage free relay - fault
- Power supply 230 V AC
- T500mA 250 V fuse
- Buzzer
- Relay function selection
- Auto reset jumper
Sensor cable - wire sensor detects water along its entire length
Line sensor cable / wired sensor / sensor cable / detects water anywhere along its length. In combination with the control panel for Eco-1 zones, the sensor cable detects water leakage, triggers an alarm and indicates the leakage zone. The cable is available in sets of different lengths: from 1 to 30 meters.
Conductive polymer technology and fluoropolymer construction make the EcoLeak sensor cable mechanically robust and resistant to corrosion and abrasion. The cable is constructed with two sensor wires embedded in a fluoropolymer support rod. The alarm module constantly monitors the continuity of the sensor cable. The cable's design allows it to be dried within seconds after water is removed and reused.
Pre-installed plastic male connector on one side, factory terminated on the other. Full technical data on the product page.
20 meter connection cable
Each kit includes a 20 meter connection cable (gray) on one side terminated with a connector to connect the sensor cable.
The water detection kit includes
- EcoLeak Eco-1 alarm panel
- Modular sensor cable that detects water anywhere along its length. Pre-installed plastic male connector on one side, factory terminated on the other side.
- Cable for connecting the sensor cable to the alarm module. Pre-installed plastic female connector on one side, factory-terminated on the other side, ready to be plugged into the terminal connectors of the alarm module.
- Adhesive clips for attaching the sensor cable to the ground.
